Checking The Position To Mount The Sensor - Pioneer SGY-PM900H90 Installation Manual

Checking the Position to Mount the Sensor

EN
Set the sensor guides for the left and right cranks, make sure the cranks are not scratched.
Right Side
1
Insert the right sensor guide into the guide base.
• Confirm there are no foreign objects on the surface of the sensor guide.
2
Insert the right crank into the guide base.
3
Make sure there are no deep scratches in the area on which the strain gauge unit is installed (diagram
below).
•
If there are scratches so deep that the base metal (silver) can be seen, measurements cannot be done and installation is not possible.
Installation can be done if the scratches are only shallow scuff marks.
4
Remove the right crank and right sensor guide from the guide base.
12