Setting The Crank Length And Calibrating Weight - Pioneer SGY-PM900H90 Installation Manual

9
Tap [Start Calibration].
The calibration starts. If the calibration is successful, "Success" appears in [Result]. It may take a up to 1 minute for the
calibration.
If "Failure" appears, the batteries may be dead or the sensors may have malfunctioned. See Troubleshooting (page 47).
Next, input the mass of the calibration weight and the crank length in the Cyclocomputer SGX-CA900 to calibrate the pedal
under load.

Setting the Crank Length and Calibrating Weight

The crank length that is set here is transmitted to the pedaling monitor sensor.
The calibration weight (mass of the weight) is recorded in the Cyclocomputer SGX-CA900, and transmitted to the pedaling
monitor sensor as tangential and radial loads are applied during calibration.
1
After performing the high accuracy zero point calibration press the
previous screen and then tap [Crank Length Setting].
2
Tap [Crank Length] and enter the length of the crank, then tap [Done].
(BACK) button to return to the
EN
Calibration
39