Calibrating With A Load On The Pedals - Pioneer SGY-PM900H90 Installation Manual

Calibrating with a Load on the Pedals

1
Measure the distance from the face of the crank arm to the center of the pedal to be used with the
system.
2
Screw the "R" end of the calibration pedal bolt into the pedal hole of the crank, adjust so length from
the surface of the crank to the outer groove is the length measured in step 1.
•
Screw in the "L" end to calibrate the left side.
•
See page 37 regarding the engraving on the calibration pedal bolt.
3
Hang the calibration weight onto the outer groove of the calibration pedal bolt.
EN
Calibration
41