Chapter 2: Legal Issues & Facts; Before Installing This Device; Defective Parts/Modules - DirectOut Technologies ANDIAMO 2.AD Hardware Manual

CHAPTER 2: Legal issues & facts
page 8 of 44
ChAPtER 2: legal issues & facts

before installing this device

warning
Please read and observe ALL of the following notes before
installing this product:
• Check the hardware device for transport damage.
• Any devices showing signs of mechanical damage or damage
from the spillage of liquids MUST NOT be connected to the
mains supply, or disconnected from the mains immediately by
pulling out the power lead.
• All devices MUST be grounded. The device is grounded
through its IEC power connections.
• All devices MUST be connected to the mains using the three-
cord power leads supplied with the system. Only supply
electrical interfaces with the voltages and signals described in
these instructions.
• Do NOT use the device at extreme temperatures. Proper op-
eration can only be guaranteed between temperatures of 5º C
and 45º C and a maximum relative humidity of 80 %, non-
condensing.
• The cabinet of the device will heat up. DO NOT place the
device close to heating sources (e.g. heaters). Observe the
environmental conditions.

defective Parts/Modules

warning
This device contains no user-serviceable parts. Therefore do NOT
open the device.
In the event of a hardware defect, please send the device to your
®
D.O.TEC representative together with a detailed description of the
fault.
We would like to remind you to please check carefully whether the fail-
ure is caused by erroneous configuration, operation or connection be-
fore sending parts for repair. See „CHAPTER 6: Troubleshooting and
Maintenance" on page 35 for assistance with troubleshooting.
®
D.O.TEC ANDIAMO 2.AD Hardware Guide - Version 1.0
DirectOut Technologies
© 2013 DirectOut GmbH
®