Thermo Scientific GeneTitan Scanner Use And Maintenance Manual page 20

3
Chapter 3 Maintain the Instrument
Lambda LS xenon arc lamp
20
Note: The 300-watt xenon lamp in the GeneTitan
hours. The instructions to remove and replace the lamp are found in "Remove the
xenon lamp" on page 20, and "Replace the xenon lamp" on page 22. After changing
the lamp, you must manually reset the lamp life clock.
Remove the xenon lamp
WARNING! Power off the lamp using the switch in the rear of the unit and
then disconnect the power cord. Allow to cool before attempting to replace the
lamp.
1. Unscrew the 4 retaining bolts with your fingers.
Remove these 4 bolts.
1
™ Scanner is warranted for 500
1
GeneTitan Scanner Use and Maintenance Guide
™