Table of Contents
Advertisement
[Auto]
3.3.10
NCT6791D Super IO Configuration
Allows you to configure the system super I/O chip parameters.
Serial Port1~2 Configuration
The sub-items in this menu allow you to set the serial port configuration.
Serial Port [Enabled]
Allows you to enable or disable the serial port (COM).Configuration options:
[Enabled] [Disabled]
The followins two items appear only when you set the Serial Port to [Enabled].
Change Settings [Auto]
Allows you to select the Serial Port base address.
Configuration options: [Auto] [IO=3F8h; IRQ=4] [IO=3F8h;
IRQ=3,4,5,6,7,10,11,12] [IO=2F8h; IRQ=3,4,5,6,7,10,11,12] [IO=3E8h;
IRQ=3,4,5,6,7,10,11,12] [IO=2E8h; IRQ=3,4,5,6,7,10,11,12]
Device Mode [RS232]
This item is only supported by Serial Port 1 and allows you to select COM RS
Mode. Configuration options: [RS232] [RS422] [RS485]
3.3.11
NCT6791D HW Monitor
Allows you to monitor the hardware status.
Smart Fan Configuration
The sub-items in this menu allow you to set the smart fan configuration.
CPU Smart Fan Control [Disabled]
Allows you to enable or disable the CPU Smart Fan Control.Configuration
options: [Enabled] [Disabled]
Chassis Smart Fan Control [Disabled]
Allows you to enable or disable the Chassis Smart Fan Control.Configuration
options: [Enabled] [Disabled]
Chapter 3: BIOS setup
Allows the system to detect the presence of USB
devices at startup. If detected, the USB controller
legacy mode is enabled. If no USB device is detected,
the legacy USB support is disabled.
3-7
Advertisement
Table of Contents
