Table of Contents
Advertisement
Quick Links
Tune-In Bed Frame - Twin and Full
Pre-Assembly:
•
Please read all instructions before beginning assembly.
•
Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or
hardware.
•
Two-adult assembly is recommended.
Parts Included:
A - Headboard – 1 pc
C - Side Rails – 2 pcs
Hardwares Included:
E - Wood Screw – 28 pcs (8x30mm)
Tools Required:
Phillips Head Screwdriver (not included)
Assembly Instructions:
Step 1 : Attach the two Side Rails (C) to the Headboard (A) and Footboard (B) by inserting the teeth at two
ends of the Side Rails (C) into the grooves on the Headboard (A) and Footboard (B). Press down
firmly to secure. See Figure 1.
B - Footboard – 1 pc
D - Slat Roll – 1 pc (14 pcs of Slat)
www.pbteen.com
Advertisement
Table of Contents
Related Manuals for PB TEEN Twin and Full
Summary of Contents for PB TEEN Twin and Full
- Page 1 Tune-In Bed Frame - Twin and Full Pre-Assembly: • Please read all instructions before beginning assembly. • Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware. • Two-adult assembly is recommended. Parts Included: A - Headboard –...
- Page 2 Figure 1 Step 2 : Lay out the Slat Roll (D) on the inner edges of the Siderails (C). Screw in each slat of the Slat Roll (D) to the Siderails (C) with the Wood Screws (E) by using a Phillips Head Screwdriver. Do not fully tighten screws until all are in place to avoid misalignment.
- Page 3 Tune-In Headboard – Twin / Full Pre-Assembly: • Please read all instructions before beginning assembly. Two adults are recommended for assembly. • Please Note: If you’ve purchased the complete Tune-In Bed, please refer to the Assembly Instructions packaged with the bed frame. Parts and Hardware Included: A –...
- Page 4 Assembly Instructions (with Wooden Bed Frame): 1. Assemble the wooden bed frame per the manufacturer’s instructions. Connect the Headboard (A) to the bed frame by joining the hooks of the bed frame’s side rails with the female connector hook of the Headboard (A).
- Page 5 Operating Instructions: 1. Make sure the power is turned off. (Toggle the Off button completely counter-clockwise). 2. Plug the small end of the enclosed AC Adapter (B) into the “PWR” port on the control panel of the Headboard (A). 3. Plug one end of Audio Cord (C) into the “IN” port on the control panel of Headboard (A), and the other end into the portable player headphone jack output.
Need help?
Do you have a question about the Twin and Full and is the answer not in the manual?
Questions and answers