Table of Contents
Advertisement
2.
Insert one edge of the DIN rail into the deeper opening of the DIN rail clip, as shown in Figure 7.
3.
Press down firmly on the UMI-7774/72 to compress the spring until the clip locks in place on the
DIN rail.
1 DIN Rail Clip
Caution
Disconnect power before removing the UMI-7774/72 from the DIN rail.
Mounting the UMI-7774/72 on a Panel
You must use a panel-mount kit to mount the UMI-7774/72 on a panel. You can order the appropriate
kit (part number 778709-01 or 778711-01) from National Instruments.
Complete the following steps to install the panel-mount kit.
Caution
Do not use screws longer than 0.25 in. to fasten the panel-mount accessory brackets to the
UMI-7774/72.
© National Instruments Corporation
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Figure 6. Fastening the DIN Rail Clip to the UMI-7774/72
1
2 DIN Rail Clip Spring
Figure 7. One Edge of DIN Rail Inserted in Clip
11
L
T S
N A
T I O
E N
N A
U M
T R
I N S
2
3
3 DIN Rail
NI UMI-7774/72 User Guide and Specifications
Advertisement
Table of Contents
