Changing The Sfp Fiber Adapter; Windows Network Configuration - Fluke OptiView III Series Getting Started Manual

OptiView TM Series III
Getting Started Guide

Changing the SFP Fiber Adapter

To install a SFP Fiber adapter, remove the protect cap and simply slide the adapter
into the fiber port until it clicks.
To remove a SFP Fiber adapter, press and hold the tabs on the sides of the SFP
adapter and pull gently out of the fiber port.
SFP fiber adapters are Class 1 laser light-emitting
products. Avoid staring into the SFP module while the
analyzer is on; otherwise injury to the eyes may occur.
It is recommended that the analyzer be powered off or placed in
suspend mode prior to changing the SFP fiber adapter. This will
reduce the possibility of damage to the SFP fiber adapter.

Windows Network Configuration

The Windows network configuration is preconfigured for communication with the
OptiView
30
15V
Figure 17. Installing a SFP Fiber Adapter
analyzer data acquisition board. The Ethernet and fiber connectors are
TM
Warning
Note
Lock/Release Tab
aww14f.eps