Cleaning The Analyzer; Has This Instrument Been Damaged In Shipping - Fluke OptiView III Series Getting Started Manual

OptiView TM Series III
Getting Started Guide
•
No serviceable parts. Do not try to service.
•
Do not connect a telephone line to this product.
•
If this product is used in a manner not specified by the
manufacturer, the protection provided by the product
may be impaired.
With an optional SFP fiber adapter installed, this product
will contain a Class 1 laser. Do not look into the laser port
because this may cause eye injury.
Use of controls or adjustments or performance of
procedures other than those specified herein may result
in hazardous radiation exposure.
To avoid possible damage to the analyzer and to the
equipment under test, follow these guidelines.
•
Use the proper terminals and cable for all connections.

Cleaning the Analyzer

To prevent moisture from entering the analyzer, clean the front panel touch display
with a moist cloth only. Do not spray water directly on the front panel touch
display. Wipe the case with a damp cloth. Do not use organic solvents, acid, or
alkali solutions.

Has This Instrument Been Damaged in Shipping?

ATTENTION!
In case of damage, call the carrier at once for inspection, and request an inspection
report. ALWAYS NOTIFY THE CARRIER FIRST! Please do not write the
factory until you have notified the carrier, since this will delay the claim.
If this precaution is not taken, we cannot assist you in recovering the amount of
claim against the carrier.
When the carrier's inspection report is obtained, you may return the instrument and
copy of the inspection report to the factory immediately.
2
Warning Class 1 Laser Product
Cautions