Linear Logic ScanGauge II Installation And Operation Manual page 7

The actual saving of the current settings occurs whenever the unit goes
to sleep or when the
If you are going to disconnect the ScanGaugeII to use it to troubleshoot
another vehicle, wait until it goes to sleep to unplug it. All settings and
trip information will be saved and will continue when it is reconnected
later.
HOME (Button with a red circle around it)
When the ScanGaugeII is running, pressing the HOME button will bring
up the following HOME screen:
If the ScanGaugeII is asleep, pressing the HOME button will cause it to
wake up to the screen it was using when it went to sleep. Pressing the
HOME button again will take it back to the HOME screen. The
following button sequences assume a start from HOME.
GAUGE> GAUGE> GAUGE> GAUGE>
Pressing the button next to
the currently selected gauges. They are automatically updated. The
following screen shows a typical gauge display:
This is a special case display. Even though there are no '
to the displayed gauges, pressing the button next to one of the gauges
will cause it to change to different gauges. For instance, pressing the
upper left button causes the display to change to:
The upper left display has changed from reading the
how much the throttle is being pressed. Pressing the button again will
change the display to the next available gauge. The selection will
continue through all of the possible gauges and then loop back to the
starting gauge.
SAVE> DONE>
or
<SCAN
<TRIP
GAUGE
causes the display to change to show
710RPM
15.2MPG
10TPS
15.2MPG
5
selections are made.
GAUGE>
MORE>
28MPH
50FWT
28MPH
50FWT
RPM
< < < < > > > >
' or ' ' next
to reading