Linear Logic ScanGauge II Installation And Operation Manual page 13

CURRENT
Pressing the
shown in the following screen:
Notice that there is no
automatically reset after the engine has been off for 8 to 10 hours (as
when sitting overnight). The values for
PREVIOUS DAY
thrown out.
The asterisk (*) in the lower right corner indicates that the ScanGaugeII
was disconnected for at least part of the day and the data may not be
complete. This will be transferred to the
the data.
NOTE: If the vehicle is driven early in the morning and then not again
until late that evening, the data will be transferred to the previous day. If
the vehicle is driven until late at night and then used again very early in
the morning, the data will stay in the
requires the vehicle be off, the ScanGaugeII connected and the vehicle
not driven for 8 to 10 hours.
TODAY
Pressing the
PREVIOUS DAY:
PREVIOUS DAY
Pressing the
display.
TANK
The selection can tell you much about the current tank of fuel.
For instance, the following display tells you that if your mileage remains
the same as it has since the last fill-up, you will run out of fuel in 92.7
Miles.
< 0.0 GALLONS >
<CURRENT
button will change to a different trip. This is
< 5.2 GALLONS >
<TODAY
RESET TODAY
for
and the values which were in
button again will change the display to the
< 10.4 GALLONS >
<PREVIOUS DAY
will change the display to the
11
RESET>
*
TODAY
. The
TODAY
will be transferred to the
PREVIOUS DAY
PREVIOUS DAY
TODAY
trip. The end of
trip will
are
along with
TODAY
TANK
trip