Linear Logic ScanGauge II Installation And Operation Manual page 33

PROBLEM: Shuts off when engine automatically turns off in a Hybrid vehicle.
CAUSE: Fuel type not set to HYBRID
SOLUTION: Use HOME>MORE>SETUP>FUEL>TYPE and then select HYBRID and
SAVE.
PROBLEM: Screen goes blank when trying to clear codes.
CAUSE: Vehicle is not responding to the "clear codes" command
SOLUTION: Sometimes multiple attempts are needed to clear the codes. Some vehicles don't
respond properly to the "clear codes" command and the codes cannot be cleared by the
ScanGaugeII.
PROBLEM: When I scan the vehicle, it says NOT READY in the second line.
CAUSE: The vehicle has not completed its "readiness" tests since the last time it was cleared or
the battery was disconnected.
SOLUTION: It will continue to say "NOT READY" until all on board diagnostic tests have
been completed. This does not mean that it is not ready to be scanned.. To get to this screen the
vehicle computer reported that no trouble codes exist. Some states require that some or all on-
board tests be completed and no trouble codes be present to pass emissions testing. When the
ScanGaugeII reports No Codes Found and READY, the vehicle is ready to pass emissions.
Some states allow some tests to not be completed and can pass the vehicle even when the
ScanGaugeII reports NOT READY.
Problem: XGauge doesn't work.
CAUSE: Data entered incorrectly. Make sure an "F" is not entered as an "E"
SOLUTION: Carefully verify that all entries are correct. A single incorrect entry can keep it
from working.
CAUSE: Vehicle doesn't support this request. Not all requests are responded to by every vehicle
within a manufacturers line over all model years.
SOLUTION: None
TROUBLESHOOTING (Continued)
31