Clear Codes - Linear Logic ScanGauge II Installation And Operation Manual

correspond to a gauge. The values in the second line are in hexadecimal
just as they are reported by the vehicle computer. You can exit this mode
using the HOME button.
NOTE: Reading the Freeze Data does not clear it. This is done when the
DTCs are cleared.
CODES
Selecting
example:
This example shows a trouble code of
trouble codes in this example, pressing
trouble code.
NEXT
Pressing
last trouble code. Pressing
the earlier trouble codes.
CLEAR
Pressing the
ScanGaugeII to verify that you want to clear the trouble code(s) and turn
off the "Check Engine" lamp.
If you want to continue to clear the trouble codes, press
decide not to clear the trouble codes, press
YES
When the button is pressed, the ScanGaugeII will send out a signal
to clear all of the trouble codes. If it is successful, the display will show:
will make the display show the trouble code. For
P0440
<PREVIOUS
P0446
<PREVIOUS
again will not change the display because we are at the
PREVIOUS
P0440
<PREVIOUS
button will result in a prompt from the

CLEAR CODES ???

<YES
CLEAR>
NEXT>
P0440
. Since there were 2 stored
NEXT
will show the other
CLEAR>
NEXT>
will return the display to show
CLEAR>
NEXT>
NO>
NO
.
8
YES
. If you