Linear Logic ScanGauge II Installation And Operation Manual page 2

WAR N I N G
Use of the ScanGaugeII while driving could lead to an accident and
serious injuries. The primary attention of the driver should always be on
safe driving. As with any gauge or other instrumentation system in a
motor vehicle, the information should be observed as part of a normal
sequence of observations performed in the operation of the vehicle.
Changes to the selections in the ScanGaugeII should only be made when
it is safe to do so. The driver must remain attentive to driving the
vehicle.
The mounting of the ScanGaugeII and the routing of the cable
connecting it to the vehicle should be done with suitable caution that it
does not create an unsafe condition. This includes but is not limited to
the following:
• Don't mount the ScanGaugeII where it can obstruct the view of the
driver.
• Don't mount the ScanGaugeII in a manner which could cause it to be
propelled through the vehicle during an accident causing injury, such
as over or near an air-bag.
• Don't route the cable in a manner which would interfere with the
operation of the vehicle controls.
R I G H T S AN D O B L I G AT I O N S
The ScanGaugeII may be used on any number of vehicles. The software
contained in the ScanGaugeII is copyright protected by Linear-Logic
and may not be transferred or disassembled and used in another product,
in part or in whole. The artwork used in generation of the circuitry is
also copyright protected and cannot be used in part or whole by any
person or entity without the express written permission of Linear-Logic.
2004-2007 Linear-Logic. All rights reserved.
Version 5.0
Information in this manual and the specifications and operation of the ScanGaugeII itself are subject to change without notice.
ii