Linear Logic ScanGauge II Installation And Operation Manual page 29

Note: A space entry exists but is at the beginning of the punctuation
symbols. You can reach it by holding down the + or - button until you
reach the punctuation.
OK
Pressing will move you to the last screen in the sequence.
CANCEL
Pressing
memory to be canceled and not saved.
NOTE: If the TXD value is blank, no name will be shown and this
XGauge memory will not appear as a selectable gauge.
SAVE
Pressing
The name will also appear in this screen if you used a non-blank entry
for TXD. In this example,
HINT: Copying to a different memory number
You can change the memory number before saving and all the data will
be written to that XGauge memory number, leaving the previously
selected memory number unchanged.
If you want to enter a gauge that is very similar to ones you have already
entered, start by pressing
copy. Step through the settings and edit the things you want to change
for the new XGauge. Before selecting
another memory number you want to save the new gauge into and then
SAVE
press .
Clearing XGAUGE memory
To clear XGAUGE memory, start as if you were going to edit the gauge.
In the TXD screen, change the first character to a space. Continue to step
through the editing fields by pressing
screen. This will actually delete the data to transmit which tells the
ScanGaugeII not to use this XGauge. The Name will not be displayed. If
you put transmit data back in to this gauge, it will be reactivated.
< XGAUGE AAA 0 >
<CANCEL
will cause all the modifications to the XGAUGE
will return you to the first XGauge screen.
< XGAUGE AAA 0 >
<EDIT
AAA
is the name.
EDIT
for the XGauge memory you wish to
SAVE>
SAVE>
SAVE
, change the number to
OK
and press
27
SAVE
to exit the