Linear Logic ScanGauge II Installation And Operation Manual page 17

PSI
Pressing the
KPA
to (kilo-pascals).
Pressing the HOME button will exit this screen with the units set to
those indicated when the HOME button was pressed.
Note: When KM is selected for distance and
measurement, the fuel economy will be reported as Liters/100Km
LHK
( ).
MORE>SETUP>ENGINE
The ScanGaugeII can be used on any number of different vehicles. On
some vehicles, the fuel economy will be more accurate if the engine
displacement is set for it. When a value is saved, it will be retained even
if the ScanGaugeII is unplugged or the vehicle battery is disconnected.
The setting can be changed at any time. If
value will be lost when the ScanGaugeII is disconnected. This may be
the desired operation if the vehicle is not to have the ScanGaugeII
regularly used on it.
MORE>SETUP>FUEL
This selection leads to a screen that allows you to set the type of fuel
used by the vehicle and the capacity of the fuel tank.
MORE>SETUP>FUEL>TYPE MORE>SETUP>FUEL>TYPE
MORE>SETUP>FUEL>TYPE MORE>SETUP>FUEL>TYPE
This screen allows fuel consumption to be more accurately computed for
different types of fuels. The selections are
HYBRID LPG
and
The upper 2 buttons can be used to step to the type of fuel used in the
vehicle. Pressing HOME will exit the screen and use the fuel selected
until the ScanGaugeII is disconnected. Pressing SAVE will place the
selection into Flash memory and use the selection until it is changed.
(pounds-per-square-inch)button will cause it to change
< 3.0 LITERS
Engine
<TYPE
<TANK SIZE
(Propane).
< GAS
Fuel Type
LITERS
SAVE
is not used, the entered
>
SAVE>
GAS DIESELa
,
>
SAVE>
15
for fuel
DIESELb
, ,