Linear Logic ScanGauge II Installation And Operation Manual page 14

TANK
In order for the
the fuel tank using
fill-up, you must use
vehicle tank has been refilled. It is also necessary to fill the tank to make
TO EMPTY
the
The estimate of distance and time to empty is based on the economy that
has been obtained so far on this tank of fuel. Right after refueling, these
values will change fairly quickly. As more of the fuel has been burned
from the tank the readings will stabilize.
It is possible to see the distance and time to empty increase as you drive.
The distance can increase as you drive at a steady fuel efficient speed.
This causes the fuel economy for the tank to rise and applying this
higher fuel efficiency to the fuel remaining in the tank can actually result
in more remaining distance. If you drive slower than the average speed
of the tank so far, the time to empty can increase.
You should refill the vehicle when there is above 50 miles/km
remaining. Pushing below 50 could result in running out of fuel.
Pressing the lower left button again will return the selection to the
CURRENT
trip. Continuing to press it will cycle the trips from one to
TANK
the next. shows different types of information in some cases from
TANK
the other trips.
MAXIMUM
data.
MORE
MORE
Pressing from the HOME display will bring up the following
display:
MORE>DISPLAY
This selection leads to buttons choices which will allow the display
backlight intensity to be changed or turned off.
< 92.7 MILES
<TANK TO EMPTY
information to be useful, you must set the size of
MORE>SETUP>FUEL>TANK SIZE
HOME>MORE>FILLUP>DONE
information correct.
substitutes
<DISPLAY FILLUP>
<SETUP
TO EMPTY
data in place of
MORE>
12
>
. When you
to indicate the