System Overview - Firecom 3010 Series Installation & Operation Manuals

S Y S T E M O R I E N T A T I O N

SYSTEM OVERVIEW

This section provides an overview of the 3010 Series Intercom System and an introduction
to its individual components. Figure 2 shows a typical system. Refer to this diagram for
each component.
INTERCOM
The main control unit for the 3010 Series Intercom System which contains all the controls
and interface circuitry.
2-WAY RADIO
The existing 2-way radio in the apparatus.
MOBILE RADIO INTERFACE CABLE
Provides the interface connections between the 3010 Series Intercom Unit and the 2-way
radio in the apparatus. There are many different cable assemblies available; the particular
cable needed depends on the make and model of your radio. Contact your local Firecom
Dealer for more information regarding an Interface Cable specific to your radio.
POWER CABLE ASSEMBLY
Provides the power connections for the 3010 Series Intercom Unit. The power connections
should be made at the same place as the power connections for your radio.
HM-10 HEADSET MODULES
Headsets are plugged into the Headset Modules to interface them into the system. The HM-
10 is the standard Headset Module for use inside the apparatus.
PP-20 PUMP PANEL MODULE
A water-resistant Headset Module for use on the exterior of the apparatus (i.e. at the pump
panel, at the tail-board, etc.).
CA CABLES
Six-conductor flat cable which connects the 3010 Series Intercom Unit to the HM-10 and the
PP-20 Headset Modules.
HM-10 Headset
2-Way
Radio
Modules
Mobile Radio
Interface Cable
FIGURE 2:
3010 Series System Overview
3010 Series
Intercom
Power Cable Assembly
+ 12 Volts DC
(Same as 2-way radio)
PP-20 Pump
Ground
Panel Module
(Same as 2-way radio)
CA Cables
2.