Digital Message Recorder - Firecom 3010 Series Installation & Operation Manuals

DIGITAL MESSAGE RECORDER

(3015 & 3025 ONLY)
The optional Digital Message Recorder (DMR) provides about 30 seconds of voice record-
ing. You can record radio communications and play them back immediately. Firecom tech-
nology provides you with unlimited, instantaneous replays of incident, address, apparatus
assignments, or other critical information. Figure 26 shows the Controls for the DMR on
the Front Panel of the 3025.
The Digital Message Recorder is ONLY available on the 3015 & 3025 models. If you have a
model 3010 or 3020, you do NOT have a Digital Message Recorder, and you may skip this
section.
RECORDING A MESSAGE
The Digital Message Recorder on the 3015 & 3025 will record every incoming radio trans-
mission. When a new message is received, the previous message will be deleted from mem-
ory unless the message is saved.
SAVING A MESSAGE
When a message is recorded that you wish to save, press and hold the DMR Button (Figure
26) until the green Record Indicator and the yellow Play Indicator flash briefly. This acti-
vates the Message Hold mode and the message will be saved.
The DMR will continue to record messages while saving the desired message. If another
transmission is received that you wish to save, follow the above procedure to save the mes-
sage.
The Digital Message Recorder saves one message at a time, any new message saved will
replace any previously saved message.
PLAYING A RECORDED MESSAGE
To play a recorded message, the message MUST first be saved. Once a message has
been saved, press the DMR Button (Figure 26) to play the recorded message. The yel-
low Play Indicator will light while the message is playing.
A Message MUST be saved BEFORE playing. You cannot play a recorded message unless it
has been saved first.
I N T E R C O M O P E R A T I O N
Record Indicator
DMR Button
Play Indicator
IMPORTANT
IMPORTANT
IMPORTANT
FIGURE 26:
Digital Message Recorder
Controls & Indicators
25.