Advertisement
S Y S T E M O R I E N T A T I O N
SYSTEM OVERVIEW
This manual provides an overview of the 3010R Series Intercom System and an introduction to its individual components. Figure 1
shows a typical system. Refer to this diagram for each component.
REMOTE HEAD
The base unit has the ability to be remotely controlled by up to two remote heads. These panels function the same as the base
unit front panel. Regardless of which button is pressed, all units will respond and update at the same time. Power to the unit is
supplied through the CA cable from the intercom. The remote head can be mounted INSIDE the apparatus either flush on a
surface or with a special bracket.
INTERCOM
The main control unit for the 3010R Series Intercom System which contains all the controls and interface circuitry.
2-WAY RADIO
The existing 2-way radio in the apparatus.
MOBILE RADIO INTERFACE CABLE
Provides the interface connections between the 3010R Series Intercom Unit and the 2-way radio in the apparatus. There are
many different cable assemblies available; the particular cable needed depends on the make and model of your radio. Contact
your local Firecom dealer for more information regarding an interface cable specific to your radio.
POWER CABLE ASSEMBLY
Provides the power connections for the 3010R Series Intercom Unit. The power connections should be made at the same place
as the power connections for your radio.
HM-10 HEADSET MODULES
Headsets are plugged into the headset modules to interface them into the system. The HM-10 is the standard headset module
for use inside the apparatus.
PP-20 PUMP PANEL MODULE
A water-resistant headset module for use on the exterior of the apparatus (e.g. at the pump panel, at the tail-board, etc.).
Advertisement
