Avaya 3600 Series Application Notes page 7

Note: In the steps that follow, the Scroll Up / Select / Scroll Down buttons refer to the
buttons whose labels are highlighted in the picture with the rectangle. The Softkeys A,
B, C and D are the buttons whose labels are highlighted in the picture with the oval.
After hearing two beeps, release the Power On / Start Call key, then release the Power
Off / End Call key.
1.
Enter the IP Address of the Phone.
Config. In the Network Setup menu, select IP Addresses. In the IP Addresses menu
that appears, select Static and press the Softkey A (OK) button.
2. Complete the IP Address Configuration. In the Static IP menu that appears, select
Phone IP. Enter a unique IP Address on the S8300 subnet and press Softkey A (OK)
button followed by the Softkey D (Up) button.
3. Configure the Default Gateway. In the Static IP menu that appears, select Default
Gateway. Enter the G350 LAN IP Address and press Softkey A (OK) button followed
by the Softkey D (Up) button.
4. Enter the Subnet Mask. In the Static IP menu that appears, select Subnet Mask. Enter
the Subnet Mask and press the Softkey A (OK) button followed by the Softkey D (Up)
button.
5. Enter the Call Server IP Address. In the Static IP menu that appears, select Call Server
IP. Enter the S8300 IP Address and press Softkey A (OK) button followed by the
Softkey D (Up) button.
6. Enter the AVPP IP Address. In the Static IP menu that appears, select AVPP IP
Address. Enter the AVPP IP Address and press Softkey A (OK) button followed by the
Softkey D (Up) button.
7. Enter the OAI IP Address. In the Static IP menu that appears, select OAI Server IP.
Enter the IP Address of the NetLink OAI server and press Softkey A (OK) button
followed by the Softkey D (Up) button.
Set the ESSID information. In the Network Setup menu, select ESS ID. In the ESS ID
8.
menu that appears, select Static Entry. Enter the ESSID that was administered on the
Avaya AP-8 (the Network Name field in Step 1 of Section 6). Press Softkey A (Save),
press Softkey D (Up) and press Softkey D (Up) to return to the Network Setup menu.
Set the Security Key. In the Security menu that appears, select WPA-PSK. In the
9.
WPA-PSK menu, select Passphrase. In the Passphrase screen, the Passphrase to enter
must match the Passphrase set on the AVPP in Step 2 of Section 6. Press Softkey A
(Save), press Softkey D (Up) until the Admin menu is reached.
DJB; Reviewed:
SPOC 2/15/2007
In the Admin menu that appears, select Network
Solution & Interoperability Test Lab Application Notes
©2007 Avaya Inc. All Rights Reserved.
7 of 28
3600-Indyme.doc