Avaya 3600 Series Application Notes page 10

1. Enter the Admin Password. If an administration password has been administered on the
phone, enter it and press the OK button.
2.
Enter the IP Address of the Phone.
Config and press the OK button. In the Network Setup menu that appears, select IP
Addresses and press the OK button. Select Static and press the OK button.
3. Complete the IP Address Configuration. In the Static IP menu that appears, select
Phone IP. Enter a unique IP Address on the S8300 subnet and press the OK button
followed by the Softkey D (Back) button.
4. Configure the Default Gateway. In the Static IP menu that appears, select Default
Gateway and press the OK button. Enter the G350 LAN IP Address and press the OK
button followed by the Softkey D (Back) button.
5. Enter the Subnet Mask. In the Static IP menu that appears, select Subnet Mask and
press the OK button. Enter the Subnet Mask and press the OK button followed by the
Softkey D (Back) button.
6. Enter the Call Server IP Address. In the Static IP menu that appears, select Call Server
IP and press the OK button. Enter the S8300 IP Address and press the OK button
followed by the Softkey D (Back) button.
7. Enter the AVPP IP Address. In the Static IP menu that appears, select AVPP IP
Address and press the OK button. Enter the AVPP IP Address and press the OK button
followed by the Softkey D (Back) button.
8. Enter the OAI IP Address. In the Static IP menu that appears, select OAI Server IP and
press the OK button. Enter the IP Address of the NetLink OAI Gateway server and press
the OK button followed by the Softkey D (Back) button.
9. Set the ESSID information. In the Network Setup menu, select ESS ID. In the ESS ID
screen, enter the ESSID that was administered on the Avaya AP-8 (the Network Name
field in Step 1 of Section 6). Press the OK button followed by the Softkey D (Back)
button.
Set the Security Key. In the Network Setup menu, select Security and press the OK
10.
button. In the Security screen, select WPA-PSK. In the WPA-PSK menu that appears,
select Passphrase and press the OK button. In the Passphrase screen that appears, the
Passphrase to enter must match the Passphrase set on the AVPP in Step 2 of Section 6.
Press OK, press Softkey D (Back) until the Admin menu is reached.
Enable OAI on the Phone. In the Admin menu, select Phone Setup. In the Phone
11.
Setup menu select Enable OAI. Select Enable and press the OK button, then press the
Softkey D (Back) twice. The label changes from Back to Exit after the first push. This
DJB; Reviewed:
SPOC 2/15/2007
In the Admin menu that appears, select Network
Solution & Interoperability Test Lab Application Notes
©2007 Avaya Inc. All Rights Reserved.
10 of 28
3600-Indyme.doc