Toa AM-CF1B Setup Manual page 8

(4) PEQ setting section
Set Frequency, Gain and Q parameters.
The setting range and initial settings are as shown in the table below:
Setting Item Setting Contents
PEQ Freq (Hz)
Gain (dB)
Q
(5) PEQ/LPF setting section
Used to set PEQ or LPF parameters.
Name
A PEQ/HPF selection
B Parameter settings
[Setting Ranges and Initial Settings]
Setting Item Setting Contents
PEQ Freq (Hz)
Gain (dB)
Q
HPF Freq (Hz)
(6) Reset button
Click this button to change the values (3) – (5) of speaker output and AUX output, respectively, as follows:
Setting Item Setting Contents
PEQ Freq (Hz)
Gain (dB)
Q
(7) APPLY button
Click this button after all settings on this screen are completed. Setting contents are applied.
Setting Range
20 to 20000
–15 to 15, 0.5 dB steps C: –6
0.267 to 69.249
Select the parameter type (PEQ or LPF).
Initial setting: PEQ
Set parameters for Freq (frequency), Gain and Q.
The setting range and initial settings are shown in the table below.
Note: Gain and Q cannot be set if LPF is selected in the PEQ/HLPF selection.
Setting Range
20 to 20000
–15 to 15, 0.5 dB steps 0
0.267 to 69.249
20 to 20000
(3) PEQ/HPF setting
section
200
0
4.318
Initial Setting
Speaker Output
C: 300
D: 600
E: 4000
D: –3
E: 8
C: 4.318
D: 4.318
E: 2.145
Description
Initial Setting
Speaker Output
10000
4.318
10000
(4) PEQ setting section
C: 630
D: 1600
E: 4000
C: 0
D: 0
E: 0
C: 4.318
D: 4.318
E: 4.318
AUX Output
C: 630
D: 1600
E: 4000
C: 0
D: 0
E: 0
C: 4.318
D: 4.318
E: 4.318
AUX Output
10000
0
4.318
10000
(5) PEQ/LPF setting
section
10000
0
4.318
8