Sintering Cercon - DENTSPLY Multimat2Sinter Instructions For Use Manual

7.6

Sintering Cercon

(Not included with all units, see section 4.6, Scope of delivery, page 15)
1.
2.
3.
4.
Fig. 23: Cercon components.
Fig. 24: Placement of the objects.
Fig. 25: Placement of the speed-sintering
bowl.
The Cercon sintering set consists of the following components:
1. Door for Cercon sintering
2. Lid for speed-sintering bowl
3. Ring for speed-sintering bowl
4. Bottom plate for speed-sintering bowl
5. Aluminium oxide beads, Ø 1.2 mm
6. Adapter plate for large-span bridges (more than 8 units).
1. Place the ring of the speed-sintering bowl on the bottom and
fill the bowl with aluminium oxide beads to a level of between
1 and 1.5 cm. Use only the aluminium oxide beads for Cercon
(REF 53 5557 0153).
2. Place the objects to be sintered on the aluminium oxide beads
and press lightly, so that all parts of the bridge are equally
supported by aluminium oxide beads.
3. Place the speed-sintering bowl and lid on the spacer pins of
the Cercon door.
NOTE!
Only hold the speed-sintering bowl by the bottom
plate when moving it, as the bottom plate, ring and
lid of the bowl are not mechanically connected.
Failure to observe this may cause the bowl to
separate into its components, and the objects could
be damaged when dropped from the bottom plate.
Page 28