Dismantling And Disposal; Safety; Dismantling; Disposal - DENTSPLY Multimat2Sinter Instructions For Use Manual

11 Dismantling and disposal

At the end of the unit's service life, dismantle the unit and dispose of properly.

11.1 Safety

 The dismantling operations described here can be performed by the operator.
Staff
Residual heat

11.2 Dismantling

To dismantle the high-temperature furnace:

Turn off the furnace and disconnect from mains.

11.3 Disposal

This device is an electrical device pursuant to the German law on the marketing, return and environmentally
compatible disposal of electrical and electronic equipment (ElektroG). The device has been labelled in
compliance with the law and marked with the following symbol:
The device is not intended for private or home use. It has been produced and furnished for commercial use
and must be disposed of properly by the last user pursuant to the ElektroG.
CAUTION!
Burn hazard caused by residual heat of the high-temperature
furnace!
Even when turned off, the unit may still be very hot from a previous
heating cycle. Burn hazard when touching the walls of the heating
chamber or the lifting plate!
Therefore:

Before working on the furnace, make sure that it has cooled
sufficiently. The furnace requires at least 12 hours to cool from
maximum temperature to approximately room temperature.
Page 42