Siemens SIMATIC C7-621 Manual page 11

04/99
Conf.Mode: Enabled
Disable
You must switch from protected mode to configuring mode. To do this, press
Wait a moment, then press
the last two steps.
Quit the mask by pressing the
In the Project menu , select the menu item Address by pressing the
in the first field, and the new address in the second field.
Old: 00
F4
Press to confirm your entry.
If you have made all the entries and settings correctly, the message NO_ERROR will appear in the
display of the C7-621-AS-i control system.
F5
Press to complete the current addressing process.
Connect the next slave to your AS-i shaped cable according to the setup diagram.
Repeat your entries in the Address menu for all slaves used in the application.
Once you have addressed all the slaves, quit the Address menu by pressing the
Getting Started with C7-621-AS-i
setconf
F5
. If the above mask appears, you may proceed. Otherwise, repeat
ESC
key once.
New: 01
Set Adr.
Setup and Configuration of the AS-i Network
F2
.
F3
key. Enter the old address
ESC
key twice.
11