Pulley Alignment; Additional Servicing - Jet HBS-916 Operating Instructions And Parts Manual

11.1.2 Servicing cutting fluid
Pour cutting fluid or coolant mixture into chip tray so
that it drains through strainer into basin. The sight
glass is located on front of base, at lower left.
Many cutting fluids on the market are formulated for
special applications. Consult your local distributor
for details if you have a long range production task
or are required to cut more exotic materials. Refer
to the cutting fluid provider's instructions for mixing
recommendations and fluid life span.
To drain cutting fluid, unscrew drain plug located at
bottom left of stand (Figure 11-3). Use pipe thread
sealant on drain plug threads when reinstalling.
Follow local regulations for disposal of used
machine fluids.
Figure 11-3: base drain plug

11.2 Pulley alignment

Periodically check alignment of belt pulleys.
Misalignment can cause rubbing and premature
wear of the belt. To adjust, loosen set screw in motor
sheave and slide sheave into alignment. Retighten
set screw.

11.3 Additional servicing

Any additional servicing should be performed by
authorized service personnel.
17