Features; Assembly - OGI TotalArc BMS 460346 SOLAR POWER Operator's Manual

KNOW YOUR PRODUCT
See Figure 1 (pg. I)
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the heater the product is being
installed on. Before use of this product, familiarize yourself
with all operating features and safety rules, in this manual.
UNPACKING
This product requires assembly.
◼ Inspect the product carefully to make sure no
breakage or damage occurred during shipping.
◼ Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
◼ Do not discard the packing material until you have carefully
inspected and satisfactorily operated the product.
PACKING LIST
OGI# 460346 – TotalArc BMS Solar:
▪
TotalArc BMS System
▪
Solar Panel w/ attached cable
▪ 3/8" U-bolt x 2" with (2) 5/16" nuts
▪
Ignition Module
▪
Ignition rod
▪
Turck Cordset x2
▪
Clam shell locks x4
▪
Ignition cable
▪
Ground cable
▪
Battery Enclosure

FEATURES

TWO CONTROL METHODS
The TotalArc BMS is configurable to operate via either
pneumatic actuation or an electronic control system.
SAFETY INPUT OPTIONS
Intelligent design allows the safety line configuration
command to be set up for electronic controls or pneumatic
systems.
REMOTE TROUBLE ALARM
The TotalArc BMS comes complete with a dry contact set
to allow you to monitor the system remotely. The dry
contact set sends a constant "OKAY" signal that ends
when there is trouble with the TotalArc BMS.

ASSEMBLY

460347 / 460348 – TotalArc VAC/VDC:
▪
▪
▪
▪
▪
▪
▪
SHIP LOOSE ITEMS
If the TotalArc system is shipped with an OGI Heater the
following components will be shipped separately as loose
items:
•
•
•
5
TotalArc BMS System
Ignitor box
Ignition rod
Turck Cordset x2
Clam shell locks x4
Ignition cable
Ground cable
Solar TotalArc BMS:
o Solar Panel with SO Cord cable
terminated at solar panel
o 12 VDC 51Ah Gel Battery
120 VAC / 12-24 VDC TotalArc BMS:
o All required components for the TotalArc
BMS will be installed on the unit prior to
shipment. No Loose Ship Components
with 120VAC Systems OR 12-24VDC
Systems
Loose shipped items MUST be stored indoors and
in a dry location