Introduction - OGI TotalArc BMS 460346 SOLAR POWER Operator's Manual

When you purchase a TotalArc BMS you purchase a product of "Quality, integrity, and innovation from concept to
commissioning." Please read through the entire manual to get familiar with installation and operations of the TotalArc BMS.
The TotalArc BMS is a flame controlling system that monitors a call for heat from pneumatic controllers upstream of the
device. When the system receives a call for heat it will attempt to light the pilot, prove the pilot for ten seconds, then ignite
the main burner. The TotalArc BMS system enforces safety shutdowns of the heater when the lighting of either the pilot or
the main burner fails. When these lockout conditions occur the TotalArc BMS forces a 5-minute purge before allowing
another relight attempt.
The operation stages of the TotalArc BMS are indicated by green and red lights installed on the front of the control enclosure.
See operation instructions for light code indication status descriptions.
The TotalArc BMS can be purchased to operate with three different power sources. Confirm power availability at installation
site and select one of the following models:
OGI Part# 460346
Solar Powered System
This system is provided with a solar panel and all required installation hardware. The solar panel provided
is sized to 35 Watts, but solar systems can be supplied with a solar panel up to 50 Watts (subject to
availability). The method of energy storage system is a 12 VDC gel battery.
OGI Part# 460347
120 VAC Powered System
This model connects to a 120 VAC power source. This model also contains an internal battery back up
system designed to maintain stable and uninterrupted power supply to the TotalArc control system. The
battery back up provided with this system is intendeded to maintain power during short time periods or
power fluctuations periods.
OGI Part# 460348
12-24 VDC Powered System
This model connects to a 12-24 VDC power source, no battery back up is included on this model. This
system typically connects to an RTU power source that will typically have a built-in power back up.
**The TotalArc BMS is a fully customizable productline – other options are available upon request. Please
speak to an OGI Sales Representative to discuss options to fit your needs**

INTRODUCTION

* * *
1