Important Safety Instructions - OGI TotalArc BMS 460346 SOLAR POWER Operator's Manual

DANGER!
Read and understand all instructions before using this
product. Failure to follow all instructions listed below may
result in electric shock, fire, serious personal injury, and/or
death.
READ ALL INSTRUCTIONS
◼ For safe operation, read, and understand all
instructions before using this product. Follow all safety
instructions. Failure to follow all safety instructions
listed below can result in serious personal injury.
◼ Do not allow untrained individuals to use this unit.
◼ Check the work area before each use.
◼ Use Safety Glasses – Always wear eye protection with
side shields marked to comply with ANSI Z87.1.
◼ Stay alert – Do not operate this unit when you are tired,
ill, upset, or under the influence of alcohol, drugs, or
medication.
◼ Do not install or operate in explosive atmospheres,
such as in the presence of flammable liquids, gases, or
dust. Area of classification at time of installation must
be General location.
◼ To reduce the risk of electric shock, this control system has
polarized connection points. Check installation
instructions.
◼ Disconnect Power source before opening control
enclosure, servicing, or performing maintenance tasks.
Use only identical manufacturer's replacement
parts and accessories. Use of any other parts may
create a hazard or cause product damage.
**Please note that each retrofit job is a custom job, additional tools may be required given the conditions and installation
of the heater
▪
Cordless Drill
▪
Drill bit (5/16")
▪
Tape Measurer
▪ Hole Saw or Punch – 1" Diameter
▪ Screw Drivers – Phillips and Flathead
▪
Wire cutters and strippers
▪
Adjustable Wrench
▪
Tubing Cutter
▪
Tubing Bender
▪
Pliers

IMPORTANT SAFETY INSTRUCTIONS

TOOLS FOR RETROFIT INSTALLATION
◼ Maintain TotalArc BMS with care – Follow instructions
for changing components. Inspect control cable
periodically and if damaged have it replaced by an
authorized service facility.
◼
Make sure all control cable clam shell guards are
properly and securely attached prior to power up
stage.
◼ Use only the manufacturer's replacement clam shells,
cables, and battery.
◼
Keep the area around the enclosure clear and free of
debris to allow proper air flow around the enclosure.
◼
If a solar unit is not operated during a prolonged
period of time, the unit's power switch should be
placed in the OFF position, but power to the unit
should be maintained ON to allow the internal
batteries to be charged.
◼
Keep solar panel covered until after full TotalArc BMS
installation. Solar panel voltage will be live and
unregulated if uncovered before installation
◼
It is recommended that units with battery back up
storage have the batteries replaced at the beginning
of each heating season to guarantee operation of the
unit during the critical operation season.
◼
If BMS is not working as it should, call OGI service
department, available 24/7 to assist you with
installation, operation, and troubelshooting.
Save these instructions. Refer to them frequently and
use them to instruct others who may use this BMS.
2