Features; Assembly - OGI TotalArc BMS 460246 SOLAR POWER Operator's Manual

KNOW YOUR PRODUCT
See Figure 1 (pg. I)
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the heater the product is being
installed on. Before use of this product, familiarize yourself
with all operating features and safety rules, in this manual.
UNPACKING
This product requires assembly.
Inspect the product carefully to make sure no
breakage or damage occurred during shipping.
Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
Do not discard the packing material until you have carefully
inspected and satisfactorily operated the product.
PACKING LIST
OGI# 460246 – TotalArc Solar:
TotalArc enclosure
Solar Panel w/ attached cable
Mounting bracket
3/8" U-bolt x 2" with (2) 5/16" nuts
Ignition Module
Ignition rod
Turck Cordset
Clam shell locks x2
Ignition cable
Ground cable
Battery

FEATURES

AUTOMATED SOLENOID VALVE
Prevents fuel from entering the fire tubes of a heater via
the main burner when the pilot light is not on or otherwise
lit.
PILOT LIGHT IGNITION PROCESS
Intelligent design allows pilot ignition when predetermined
conditions are met and shuts down both the pilot and main
gas fuel systems when conditions are not met.
NON-FAILURE POINT SYSTEM
If the TotalArc loses power or suffers a fatal error, it will not
affect or interrupt heater operations.

ASSEMBLY

460312 / 460371 – TotalArc VAC/VDC:
SHIP LOOSE ITEMS
If the TotalArc system is shipped with an OGI Heater the
following components will be shipped separately as loose
items:
•
•
•
5
TotalArc enclosure
Ignitor box
Ignition rod
Turck Cordset (P-RKG-8T-1250-3-RSG-8T-
M12)
Clam shell locks
Ignition cable
Ground cable
Solar TotalArc:
o 12 VDC 18 Ah Battery (Batteries are fully
charged prior to shipment)
o Solar Panel with SO Cord cable
terminated at solar panel
120 VAC TotalArc
o All required components for the TotalArc
will be installed on the unit prior to
shipment. No Loose Ship Components
with 120VAC Systems
Loose shipped items MUST be stored indoors and
in a dry location