Customization Basics; Side Panels; Optional Accessory Kits; Refrigerator Location - Monogram 36” Installation Instructions Manual

Design Guide - Stainless Steel Installation

CUSTOMIZATION BASICS:

Stainless Steel Wrapped Refrigerators
Stainless Steel wrapped refrigerators have wrapped
doors and grille panel, beveled edges, and tubular
stainless steel handles that coordinate with other
Monogram appliances. These models are shipped
ready for installation. These models do not include
handles.
Statement Handle
ZKSB2H2PNSS
Minimalist Handle
ZKSB2H2CNSS
*Optional Handles - When ordering this product, be
sure to use the model number associated with the
chosen handle.

SIDE PANELS

Side panels must be used whenever the sides of the
refrigerator will be exposed. The 1/4
panels will slip into the side case trim. Secure the
panels to the refrigerator with stick-on hook and loop
fastener strips. Order the side panels from the cabinet
manufacturer.
• Cut a notch in the top front corner as shown to allow
clearance for corner keys in the front side trim.
* Depending on
installation height.
(0.63 cm) side
"
24"
3/16"
1-7/8"
*84"
*3" to 4"
2-9/16"

OPTIONAL ACCESSORY KITS

ZKBSN720SS: Unification kit for an integrated
appearance on 2 stainless steel models installed
side-by-side.

REFRIGERATOR LOCATION

• Do not install the refrigerator where the temperature
will go below 55°F (13°C). It will not run often
enough to maintain proper temperatures.
• Do not install the refrigerator where temperatures will
go above 100°F (37°C). It will not perform properly.
• Do not install the refrigerator in a location exposed to
water (rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it fully
loaded.
26
31-1000452 Rev. 1