MasterCraft 299-3117-6 Instruction Manual page 8

Table of Contents

Advertisement

8
model no. 299-3117-6 | contact us 1-800-689-9928
SAFETY GUIDELINES
headline bars
headline bars
RISK OF BURNS. High temperatures are generated by the
pump and manifold. To prevent burns or other injuries, DO
NOT touch the pump, manifold or transfer tube while the
pump is running. Allow them to cool before handling or
servicing. Keep children away from the compressor
at all times.
continuation tabs
continuation tabs
RISK TO BREATHING. Be certain to read all labels when you
are spraying paints or toxic materials, and follow the safety
instructions. Use a respirator mask if there is a chance of
inhaling anything you are spraying. Read all instructions and
be sure that your respirator mask will protect you. Never
directly inhale the compressed air produced by a compressor.
notes
notes
It is not suitable for breathing purposes.
RISK OF EYE INJURY. Always wear ANSI Z87.1 approved
safety goggles when using an air compressor. Never point
any nozzle or sprayer toward a person or any part of the
body. Equipment can cause serious injury if the spray
penetrates the skin.
RISK OF BURSTING. Do not adjust the relief valve for any
reason. Doing so voids all warranties. The relief valve has
been pre-set at the factory for the maximum pressure of this
warnings
warnings
unit. Personal injury and/or property damage may result if the
relief valve is tampered with.
RISK OF BURSTING. Do not use plastic or PVC pipe for
compressed air. Use only galvanized steel pipe and fittings for
compressed air distribution lines.
RISK TO HEARING. Always wear hearing protection when
using an air compressor. Failure to do so may result in
hearing loss.
The power cord on this product contains lead, a chemical
known to the State of California to cause cancer, and birth
defects or other reproductive harm. Wash hands after
handling.
NOTE: ELECTRICAL WIRING. Refer to the air compressor's
serial label for the unit's voltage and amperage requirements.
Ensure that all wiring is done by a licensed electrician, in
accordance with the Canadian Electrical Code.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents