Table of Contents
Advertisement
Local Configuration
P
S
ERFORMING
YSTEM
Use this procedure to perform the system maintenance commands
listed.
1
From the Main menu, select 6. System Maintenance.
2
From the System Maintenance menu, select
•
1. Force/APS Commands, and then select
1. Commands for Optical Facilities to view
and force line protection for the available circuits,
•
2. Reset/LED Test Commands to reset the selected
D3LX module or verify that its LEDs are working properly,
•
4. Loopback Status Commands, and then select 1,
High/Low Speed Loopback Status/Commands
to view the loopback status or perform loopbacks on the
selected D3LX, or
•
8. Trouble Isolation (as shown in
page
31), and then select the Group and Slot.
3
Use
,
SPACEBAR
display, populate each data field according to your requirements,
then assign the selections by pressing
30
M
AINTENANCE
,
,
, and
to select the group and slot to
ENTER
August 30, 2002
Figure 18 on
.
LTPS-UM-8013-03
6. System Maintenance
1. Force/APS Commands
2. Reset/LED Test Commands
3. Execute ACO (Alarm Cut-Off)
4. Loopback Status/Commands
5. Display Inventory
6. Display Circuit IDs
7. SCU-860 Data Transfer
8. Trouble Isolation
9. Metallic Loop Qualification
(MLQ Capable Chassis Required)
D3LX CO and RMT Modules
Advertisement
Table of Contents
