Table of Contents
Advertisement
Installing a D3LX CO Module in an LEC
4
Locate the mounting slots designated for the D3LX CO modules in the chassis.
5
Refer to
Figure 6 on page 11
signal.
–
If no protection switching is required, proceed to the next step.
–
If protection switching is required, a working module may be installed in the first slot of any quad group,
such as 1-1, 2-1, 3-1, 4-1, 5-1, 6-1, or 7-1. The protection module is installed in the slot to its immediate
right in the order of 1-3, 2-3, 3-3, 4-3, 5-3, 6-3, or 7-3. For more information on protection switching,
refer to
"Protection Switching" on page
Install the working module first, then the protect module.
10
Fiber patch cord
FiberGuide vertical duct
Figure 5. Routing the Fiber Patch Cord
for D3LX CO module locations chassis and slot corresponding to the DS3
4.
August 30, 2002
Heat baffle/fiber management panel
D3LX CO and RMT Modules
LTPS-UM-8013-03
Advertisement
Table of Contents
