Table of Contents
Advertisement
1.5
INFORMATION FOR USERS IN THE UK
WARNING: THIS APPLIANCE MUST BE EARTHED
This apparatus is supplied with an approved moulded 13A plug.
To change a fuse in this type of plug proceed as follows:
1 Remove fuse cover and fuse.
2 Fit new fuse which should be a BS 1362 5A,A.S.T.A. or BSI approved
type.
3 Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should be cut
off and an appropriate 3-pin plug fitted in its place.If the mains plug
contains a fuse, this should have a value of 5A.
If a plug without a fuse is used, the fuse at the distribution board should
not be greater than 5A.
Note:
The severed plug must be destroyed to avoid a possible shock hazard
should it be inserted into a 13A socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured in accordance with the
following code:
■
BLUE - "NEUTRAL" ("N")
■
BROWN - "LIVE" ("L")
■
GREEN & YELLOW - "EARTH" ("E")
1 The GREEN AND YELLOW wire must be connected to the
terminal in the plug which is marked with the letter "E" or by the
Earth symbol
or coloured GREEN or GREEN AND YELLOW.
2 The BLUE wire must be connected to the terminal which is marked
with the letter "N" or coloured BLACK.
3 The BROWN wire must be connected to the terminal which
marked with the letter "L" or coloured RED.
Before replacing the plug cover, make certain that the cord grip is
clamped over the sheath of the lead - not simply over the three wires.
7
User Manual 190S6FGT
Advertisement
Table of Contents
