User Manual 190S6FGT
For Windows® Me
1 Start Windows® Me.
2 Click on the 'Start' button.
3 Select 'Settings', then click on 'Control Panel'.
4 Double click on the 'Display' icon.
5 Select the 'Settings' tab, then click on 'Advanced...'.
6 Select the 'Monitor' button, then click on 'Change...' button.
7 Select 'Specify the location of the driver(Advanced)' and click on the
'Next' button.
8 Select 'Display a list of all the drivers in a specific location, so you can
choose the driver you want', then click on 'Next'.
9 Click on 'Have Disk...'.
10 Click on the 'Browse...' button, select the appropriate drive F:
(CD-ROM Drive).
11 Click on the 'OK' button.
12 Click on the 'OK' button, select your monitor model.
13 Click on the 'Next' button.
14 Click on 'Finish' button, then the 'Close' button.
For Windows® 2000
1 Start Windows® 2000.
2 Click on the 'Start' button.
3 Select 'Settings', then click on 'Control Panel'.
4 Double click on the 'Display' icon.
5 Select the 'Settings' tab, then click on 'Advanced...'.
6 Select 'Monitor'
If the 'Properties' button is inactive, it means your monitor is
●
properly configured. Please stop installation.
If the 'Properties' button is active. Click on 'Properties' button.
●
Please follow the steps given below.
7 Click on 'Driver', then click on 'Update Driver...'.
8 Click on the 'Next' button.
9 Select 'Display a list of the known drivers for this device so that I can
choose a specific driver', then click on 'Next'.
10 Click on 'Have disk...'.
11 Click on the 'Browse...' button, then select the appropriate drive F:
(CD-ROM Drive).
12 Click on the 'Open' button, then click on the 'OK' button.
13 Select your monitor model, then click on the 'Next' button.
14 Click on the 'Finish' button, then the 'Close' button.
If you can see the 'Digital Signature Not Found' window, click on the
'Yes' button.
20