Table of Contents
Advertisement
User Manual 190S6FGT
Symptom
You touch the touch screen but the
cursor appears in a different place.
Cursor is extremely jittery or erratic.
Cursor lags finger.
Possible Cause
The touch panel is not correctly aligned to
your monitor.
Wrong setting of the operating frequency.
Incorrect baud rate.
For further assistance, refer to the Consumer Information Centers list
and contact your local Philips distributor.
38
Remedy
1 From DOS re-run the MKSCR.EXE
(from Windows re-run the WMKSCR.EXE)
program. Realign the touch screen to your
monitor. Run the application file.
If the problem persists go to 2.
2 You may have stored the source files in
different directories or folders when you ran
the INTCMS and RTOUCH (display mode
parameter). Another possibility is that there
may be a conflict between the application
mode and MKSCR display modes.
3 If you have access to functioning models of
the touch screen and the controller box try
the following! Remove the touch screen and
replace it with the functioning model. Re-run
the MKSCR.EXE program. If the problem is
solved then your original touch screen is
broken. Contact your dealer for help. If the
problem persists, replace the controller box
with a functioning model.
Re-run the MKSCR.EXE program. If the
problem is solved then your original
controller box is broken. Contact your
dealer for help.
Adjust the operating frequency at the touch
screen control panel.
Lower the baud rate of the touch screen driver.
Advertisement
Table of Contents
