User Manual 190S6FGT
6.1.2
PC CONNECTIONS
1 Turn off your computer and unplug its power cable (1).
2 Connect the VGA signal cable to the video connector (2) on the
back of your computer. Secure the cable by turning the screws on
the connector clockwise.
3 Connect the serial (female RS-232) cable to the serial port on the
back of your PC (3). Secure the cable by turning the screws on the
connector clockwise.
4 Disconnect the male PS/2 connector from the keyboard port of the
PC and connect it to the female PS/2 connector of the flying lead
from the serial (female RS-232) cable (4).
5 Plug the male PS/2 connector of the flying lead from the serial
(female RS-232) cable in the keyboard port of the PC (5).
6 Connect the speaker connector to your PC audio output (6).
7 Plug the power cord of the touch screen monitor and your
computer into an outlet (7).
8 Turn on your computer and touch screen monitor. If the monitor
displays an image, the installation is complete.
9 If the image is not centered within the screen area, use the monitor
controls to adjust the image.
See chapter Basic Functions for more information.
1
4 5
4
3
1 6
18
2
2
7