Dismantle The Bed - Invacare Etude Plus User Manual

In order to prevent the cables from being torn apart when activating
the motors, follow the instructions below.
1. Connect the cables of the bed end motors (head and foot end)
directly to the control box.
2. The plug of the thigh motor must be directed through the opening
of the supporter for the backrest motor and then be connected
to the control box.
3. Connect the main cable plug to the 230 V socket.
4. Run the motors of the bed ends to their top position.
5. Place the motor cable of the foot end on the hook at the foot end.
6. Run the backrest to its top position.
7. Place the head end motor cables on the four hooks at the head
end.
8. Fasten the safety clip to the control box.

3.4 Dismantle the bed

1. Dismantle side rails and lifting pole.
2. Bring the bed to its lowest position and adjust all mattress
support sections to horizontal position.
3. Disconnect the 230 V supply. Roll the cable onto the hook of
the head end of the bed.
4. Disconnect all the motor plugs from the motors (do not
disconnect the backrest motor cable).
5. Dismantle the safety comb from the control by means of a tool,
e.g. a flat headed screwdriver.
6. Pull out the cables of the bed end motors and leg section motor.
7. Separate the mattress support from the bed ends.
8. Divide the head and foot end of the mattress support.
9. For beds with 24 V external power supply, verify that mains cable
is attached to control unit power supply cable.
1567454-A
Setup
7