Electromagnetic Compliance (Emc) - Invacare Etude Plus User Manual

Etude Plus

9.5 Electromagnetic compliance (EMC)

Guidance and manufacturer´s declaration – electromagnetic emission
The medical bed is intended for use in the electromagnetic environment specified below. The customer or the user of the bed should assure
that it is used in such an environment.
Emissions test Compliance
RF emissions
Group I
CISPR 11(partly)
RF emissions
Class B
CISPR 11(partly)
Harmonic emissions
Class A
IEC 61000-3-2
Voltage fluctuations /
flicker emissions Complies
IEC 61000-3-3
Guidance and manufacturer´s declaration – electromagnetic immunity
The medical bed is intended for use in the electromagnetic environment specified below. The customer or the user of the bed should assure
that it is used in such an environment.
Immunity test IEC 60601 test level
Electrostatic
± 6 kV contact
discharge (ESD)
± 8 kV air
IEC 61000-4-2
Electrostatic ± 2 kV for power supply
transient / burst lines
IEC 61000-4-4 ± 1 kV for input/output lines
Surge ± 1 kV differential mode
IEC 61000-4-5 ± 2 kV common mode
< 5% U
for 0,5 cycle
Voltage dips, short
interruptions and 40% U
voltage variations on 5 cycles
power supply input
70% U
lines
25 cycles
IEC 61000-4-11
< 5% U
for 5 sec
Power frequency
(50/60 Hz) magnetic
3 A/m
field
IEC 61000-4-8
16
Electromagnetic environment - guidance
The medical bed uses RF energy only for its internal function. Therefore, its RF emissions are
very low and are not likely to cause any interference in nearby electronic equipment.
The medical bed is suitable for use in all establishments including domestic establishments
and those directly connected to the public low-voltage power supply network that supplies
buildings used for domestic purposes.
Compliance level
± 6 kV contact
± 8 kV air
± 2 kV for power supply
lines
± 1 kV for input/output lines
± 1 kV differential mode
± 2 kV common mode
(>95% dip in U ) < 5% U
T T
for 0,5 cycle
(60% dip in U ) for 40% U
T T
5 cycles
(30% dip in U ) for 70% U
T T
25 cycles
(>95% dip in U ) < 5% U
T T
for 5 sec
3 A/m
Electromagnetic environment – guidance
Floors should be wood, concrete or ceramic tile. If floors
are covered with synthetic material, the relative humidity
should be at least 30 %.
Mains power quality should be that of a typical commercial
or hospital environment.
Mains power quality should be that of a typical commercial
or hospital environment.
(>95% dip in U )
T T
Mains power quality should be that of a typical commercial
or hospital environment. If the user of the medical
(60% dip in U )for bed requires continued operation during power mains
T T
interruptions, it is recommended that the medical bed
be powered from an un-interruptible power supply or
(30% dip in U ) for
T T
a battery.
U is the a. c. mains voltage prior to application of the
T
(>95% dip in U )
T T
test level.
Power frequency magnetic fields should be at levels
characteristic of a typical location in a typical commercial
or hospital environment.
1567454-A