Fastbind Elite User Manual page 16

7.1.3
a)
c)
7.1.4
7.1.5
a)
7.2. ROUGHENING AND HOT MELT APPLICATION
7.2.1
rev. d5 Elite Multilang
© 2004.12 Maping Co
Place the papers that make the book between the strip and
clamp.
a, b) Adjust the block from side and top carefully to ensure
that it aligns correctly with the cover.
c) Push out air between pages using both hands.
d) Since strip cannot be aligned against paperguide,
check that strip is positioned correctly: strip edge and
b)
papers are on same line.
d)
Push the clamp forward and lock it by lifting the clamp
handle up. To keep the turntable still during this action, put
your left hand on clamp's left knob when lifting the handle.
Turn the table over (UP) by pushing the operating handle up.
a, b) Fold the strip back and the block is ready for
b)
THICK BOOKS OR BOOKS WITH COATED PAPER:
Roughen book spine 1-3 times. Repeat if necessary.
Roughening opens the paper grain on book spine and
improves binding result with diffi cult materials. Note that
roughening several times increases spine width. Too heavy
roughening results unsquare book spine.
1 - 15
BINDING WITH STRIP
adhesive application.
www.maping.com