Table of Contents
Advertisement
When Operations Are Interrupted
When the Message "STOPPED FOR MOTOR PROTECTION" Is Displayed
This message indicates that the machine's operations have been canceled in order to prevent pump motor malfunctions
arising from overheating.
If this message is displayed, press the sub power switch to turn the sub power off. Then, wait 10 minutes before turning the
sub power switch on again. The operation will continue from the point where it was interrupted.
When the Cleaning/Wiper Replacement Operation Is Interrupted
STEP 3: Cleaning of the Periphery of the Print Heads (Manual Cleaning)
STEP 4: Replacing the Wipers and Felt Wipers
If you interrupt the above operations partway through the procedure, you cannot continue the operations with the proce-
dures in this manual.
The subsequent work to perform varies depending on the point when the operations were interrupted. Refer to the follow-
ing sections, and then perform operations according to the corresponding page of the user's manual of the model that you
are using.
When the interruption occurs
during cleaning the periphery
of the print heads (P. 8 and 9)
When the interruption occurs
during wiper replacement
(P. 10 and 11)
When the interruption occurs
during felt wiper replacement
(P. 11 and 12)
If you do not perform all the operations, color mixing between the MAX 2 ink and MAX 3 ink will occur. If you interrupt
operations partway through the procedure, be sure to perform the remaining operations from the point the procedure was
interrupted.
20
ECO-SOL MAX 3 Ink Switching Method
Operations that must be performed
The following are the section titles in the table of contents of the user's manual (Chapter 3 Maintenance).
Manual Cleaning
Replacing the Felt
Replacing the Wipers
Replacing the Felt
Replacing the Wipers
Replacing the Felt
Wipers
Wipers
Wipers
Advertisement
Table of Contents
