Protecting The Environment - Black & Decker BDM200L Quick Start Manual

ENGLISH
4. Edge guide
5. Manual retraction button
6. Battery cover
7. Belt clip
Assembly
Warning! Make sure that the tool is switched off.
Fitting the batteries (fig. A)
Warning! Use LR44 battery cells only.
Open the battery cover (6).
x
Insert the batteries into the tool in the orientation as shown.
x
Close the cover and let it click into place.
x
Using the edge guide (fig. B)
The edge guide (4) is used to project the laser line square to
the edge of the workpiece.
For left-handed use, slide out the guide located at the left
x
side.
For right-handed use, slide out the guide located at the
x
right side.
Rotating the laser head (fig. C & D)
The laser head (2) can be rotated to allow projection of the
laser line in both directions.
While holding the tool with one hand, use the thumb and
x
index finger of your other hand to rotate the head.
Make sure to control the spring pressure once the head is
x
halfway.
Gently let the head jump into its position.
x
Use
To extend the tape, pull the tape hook (3).
x
To retract the tape, press the retract button (5).
x
Warning! Keep your fingers away from the tape on retraction.
Do not retract long pieces of tape in one go.
x
Dab the button (5) to control the speed of retraction.
Using the laser function
The laser line extends the measurement across the workpiece
to aid in marking out prior to sawing applications.
Switching on and off
To switch on, slide the switch (1) into position I.
x
To switch off, slide the switch (1) into position 0.
x
Hints for optimum use
The laser line also provides support in surface layout of
materials and/or objects at equal distances (fig. E).
4
Cleaning and maintenance
Your tool has been designed to operate over a long period of
time with a minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and regular cleaning.
To clean the tool, use only mild soap and a damp cloth.
x
Never let any liquid get inside the tool and never immerse
any part of the tool into liquid.
Checking and calibrating the laser head (fig. D)
The laser head (2) is factory-adjusted and does not require
adjustment before first use.
However, if the tool has received rough treatment during use,
and the laser line is out of alignment, the laser head can be
calibrated as follows.
Place the tool close to the square corner of a worktop.
x
Place the tool flush to the edge of the worktop using the
edge guide.
Check that the laser line aligns with the square edge.
x
If adjustment is required, proceed as follows:
x
Turn the screw (8) in or out as necessary, until the laser
x
line aligns with the square edge.

Protecting the environment

Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your Black & Decker product
needs replacement, or if it is of no further use to you, do not
dispose of it with household waste. Make this product
available for separate collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand for
raw materials.
Local regulations may provide for separate collection of
electrical products from the household, at municipal waste
sites or by the retailer when you purchase a new product.
Black & Decker provides a facility for the collection and
recycling of Black & Decker products once they have reached
the end of their working life. To take advantage of this service
please return your product to any authorised repair agent who
will collect them on our behalf.