Toshiba V Series Installation And Wiring Manual page 22

Integrated controller information and control network module

Hide thumbs Also See for V Series:

Table of Contents

Chapter 2 TC-net 100 Cabling (Optical Fiber Cable)

• Clamp the cables so that the connectors will be free of the cable weight and the force

of cable bends.

• After wiring, check that the cables satisfy the allowable bending radius requirements

specified in Table 2-1 Allowable Cable Bending Radiuses on page 10. If any cable is

found not satisfying the requirements, install it again so its bending radius is equal to,

or greater than, the figures specified in the table.

Table 2-1 Allowable Cable Bending Radiuses

Cable

Optical fiber cable

Optical fiber cord

Allowable Bending Radius (mm)

Outer Size (mm)

Clamped

17.0

170

5.0

Installed

20 times cable

OD or more

TC-net 100 Installation and Wiring Manual

Table of Contents

Tc-net 100