Installation And Wiring Of Electrical Shared Hub Unit - Toshiba V Series Installation And Wiring Manual

Chapter 4 Installation and Wiring of TC-net 100 Parts

4.2 Installation and Wiring of Electrical Shared Hub Unit

4
26
To install a hub, fasten it to the cabinet. Observe the allowable cable bending radius
requirements, and clamp the cables after connection.
• Place a dust cover on the unused connectors (modular connectors), and connect nothing to
them.
Install a hub as follows:
(1) Place the hub on the cabinet mounting plate, and fasten it with the brackets
(supplied) on both sides.
(2) Fasten the cabinet mounting plate to the cabinet.
(3) Connect the power cable to the hub.
(4) Insert the twisted-pair cables having an RJ45 connector at both ends into the hub's
modular connectors and push them in to lock.
Cabinet
Cabinet mounting
plate
Twisted-pair
cables
（*1) If the cabinet is not of the grounding exclusive to the Integrated Controller, insulate
the hub from the cabinet.
Caution
Hub
19-inch rack size
Figure 4-11 Installing and Wiring Hub
Supplied bracket
TC-net 100 Installation and Wiring Manual