Water Connection; Mains Power Connection - Nilfisk-Advance SH TRUCK Instructions For Use Manual

3.4 Water connection

3.5 Mains power connection

Original Instructions
The water connection is made
with a fl exible hose connected
to the water tank (7) of the
machine.
The water hose can be lead in
through:
1. The bottom plate
2. The punch-out pieces in the
rear plate
(see foldout at the end of this
manual).
Make sure that the supply
hose is suited for the purpose
(temperature and fl ow rate). If
in doubt, contact your Nilfi sk
representative.
CAUTION! An
authorized electri-
cian must perform
the electrical
connection of the machine to
the main power supply. Refer to
section "1 Safety precautions
and warnings".
The connection can be made to
a public drinking water supply
network or a private water sup-
ply. Water quality: particle size
<50  A shut-off cock should
be mounted on the water sup-
ply network in the immediate
vicinity of the machine. Make
sure that the water supply is
within the following specifi ca-
tions and that the water does
not contain particles such as
fl oating sand.
Min. water inlet pressure: 1 bar
(at the required fl ow rate of the
machine - see data plate.
Max. water pressure: 10 bar
Max. water inlet temp.: 30°C.
All SH TRUCK feature a water
tank, and no further protection
against back-fl owing water into
the supply network is required.
The machine complies with EN
1717.
If there is a risk of fl oating sand
or other impurities in the inlet
water, a sand fi lter (50 micron)
should be mounted between the
supply outlet and the internal
fi lter of the machine.
The following precautions must
be observed:
 Make sure that the supply
cable is of the correct dimen-
sion (see voltage and load on
the data plate of the machine)
and is suitable for the specifi c
environment.
SH TRUCK
7