Nilfisk-Advance SH TRUCK Instructions For Use Manual page 15

3
4
4.2.2 Operation - automatic
start/stop
4.2.3 Running with hot water
Original Instructions
+
The SH TRUCK is equipped
with a diesel unit to heat the
water.
The diesel unit can be switched
on or off at convenience by
pushing the white "Heating"
push button (5). Pushing the
button once will turn on the light
in the button and switch ON the
diesel unit.
Pushing the button again will
turn out the light in the button
and switch OFF the diesel unit.
5
3
4
If the motor of the SH TRUCK
does not start or stops unin-
tendedly with the red "STOP"
push button (4) fl ashing, an
error is present. Read the error
-
(A)
(B)
1
2
3
4
5
6
DC
7 IN PU
8 T
9
10
message through the "Inspec-
11
12
13
14
15
ESC
+
tion window" and refer to sec-
OK
tion "7 Troubleshooting".
The SH TRUCK is automatically
started when the trigger (1) of
the spray handle is activated
and will automatically stop and
enter standby mode when the
trigger is released.
1 When the machine is not in
use, the trigger should be
locked with locking device.
The temperature can be
adjusted within the limits stated
on the "Thermostat" (8), by
turning the button to the desired
value. When the diesel unit is
ON (push button (5) alight), the
control unit of the SH TRUCK
will monitor the water tempera-
ture and regulate the diesel unit
to provide the preset tempera-
ture.
If an error occurs to the heat-
ing system of the SH TRUCK,
the machine stops and the red
"STOP" push button (4) will
start fl ashing and the diesel unit
will be shut off. The SH TRUCK
will continue to be functional
with non heated water by push-
ing the green "START" push
button (3).
In this case please refer to sec-
tion "7 Troubleshooting".
SH TRUCK
Always hold the
spray lance with
both hands!
15