Maintenance - Nilfisk-Advance SH TRUCK Instructions For Use Manual

SH TRUCK
5.7.2 Building and equipment
Task
General surfaces
Metallic equip-
ment
Rusted or dam-
aged surfaces
prior to treatment
These are merely several examples of cleaning tasks that can be solved by a pressure washer in as-
sociation with accessories and detergents. Each cleaning task is different. Please consult your local
dealer or Nilfi sk representative in order to discuss the best solution for your own cleaning tasks.

6 Maintenance

22
Accessories
Foam injectors
Standard lance
Curved lances
Tank cleaning head
Detergents
Intensive
J25 Multi
Combi Active
Alkafoam
Disinfectant
DES 3000
Wet sand blasting equip-
ment
To ensure the most optimal
maintenance of your SH
TRUCK, you should consi der
making a "Service Contract"
with Nilfi sk. In this way your SH
TRUCK will always be ahead of
potential problems.
Though paying attention to a
few things will ensure a pro-
longed and reliable operation of
your SH TRUCK.
Therefore it will be a good idea
to make a habit of the following:
Method
1. Apply thick foam over the surfaces to be cleaned.
Apply on dry surfaces. Apply from top to bottom
on vertical surfaces. Let the foam act for up to 30
minutes for the optimal effect.
2. Proceed with cleaning using the high-pressure
lance. Use applicable accessories. Use high-
pressure to dislodge large amounts of incrusted
dirt or grime. Use lower pressure and high water
volume in order to rapidly fl ush away loose dirt
and rinse surfaces.
3. Apply DES 3000 disinfectant once the surfaces
are perfectly clean.
Areas covered by amounts of loose dirt, such as
animal remains in slaughterhouses, can be re-
moved by using high water fl ow to fl ush away the dirt
to evacuation pits or drains.
Tank cleaning heads can be used to clean barrels,
vats, mixing tanks etc. Cleaning heads may be
hydraulically or electrically powered and give the
possibility for automatic cleaning without a constant
user.
1. Connect the sand blasting lance to the pressure
washer and place the suction tube in the sand.
2. Always wear protective equipment during sand
blasting.
3. Spray the surfaces to be treated with the mix of
water and sand. Rust, paint etc will be stripped
off.
Prior to attaching the high-pres-
sure hose, the quick couplings
should be cleaned of dust and
sand. Flush if necessary. This
will prevent a clogging up of the
nozzle.
Prior to attaching the spray
lance or other accessories to
the spray handle, the machine
should be started and the quick
coupling cleaned of dust and
sand.
Original Instructions